Detailed Product Description

 Installation  Instructions:

The detector must be installed in a convenient weatherproof location as close to the loop as possible. Installation location must choose to stay away from the heat source; it around other devices must maintain a distance of at least 10mm (must not installation close with boxes wall). A correct loop configuration and detector installation will ensure a successful inductive loop detection system. Loop of several important parameters include: loop figure, size, turns, install methods.

Technical Data:

1. Operating voltage: 220V AC ±10%

2. Power Consumption: ≥5VA     

3. Output relays:  240V/5A AC

4. Frequency range:  20 kHz to 170 kHz

5. Reaction time: 10ms

6. Signal holding time: Unlimited / limited when loop is permanently covered 10 minutes

7. Sensitivity: adjustable in 8 increments

8. Wiring: 50μH and 300μH. Ideal is 150μH

9. Loop connection wiring: Maximum length 200 meters, twisted at least 20 times per meter

10. Autocorrecting time:  1to 2seconds

11. Operating temperature: -20°C to +65°C

12. Storage temperature: -40°C to +85°C

13. Dimensions (include pedestal ): 78x40x108 mm (L x W x H)

14. Net Weight include pedestal: 265g

Specific set the table below. In trial runs, first sensitivity in the lower stalls, the actual test vehicle detection if no response should be an increased sensitivity to stall, so repeated several times until the car seized stability for normal work.